Roving Networks RN-370 Uživatelský manuál stáhnout pdf (Strana 44)

Wireless Products Division

CONFIDENTIAL

Lab 2: Forwarding TCP

packets

 When Data Is Written to Module’s UART, TCP Packets

Forwarded Based On

 Flush timer

 Flush size

 Match character

 TCP Packet Sent When Any of These Events Occur

 Parameters Logically ORed to Determine when TCP Packet Is Sent

 When Configured Correctly, Module Can Be Optimized for Low Latency or High

Throughput

 Low latency: use lower flush timer value & flush size

 High throughput: use higher flush timer value & flush size

Tip: Module Tries to Optimize Automatically for Bandwidth

by Increasing Default Flush Size with Higher Baud Rates

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 69 70

April, 2012 1
Wi-Fi™ Overview 2
Firmware 4
Roving Networks Firmware 5
Firmware Extensions 6
Wi-Fi Lab: Introduction 9
Lab Agenda 10
Data & Command Modes 11
Command Mode: 12
Configuration Settings 12
Command Mode: Syntax 13
Keywords 14
Hardware Architecture: Key 15
Features 15
Hardware Architecture: 16
Silicon 16
Development Environment 17
Wi-Fi Lab 18
Lab Prerequisites 19
Lab 1: Association & UDP 20
Lab 1: Hardware Setup 22
Launch Command Mode 23
Lab 1: Joining/Associating 24
Lab 1: Interim Summary 25
UDP with PortPeeker 26
Lab 1: UDP Broadcast 27
 Set Device ID 28
 Set Broadcast UDP Port 28
Enter command mode 29
Lab 1: UDP Auto Pairing 30
Mode (Optional Slide) 30
Lab 1: Conclusion 31
Lab 2: TCP 32
Lab 2: TCP Connections 33
Lab 2: Setup PortPeeker 34
Lab 2: Open TCP Connection 35
WiFly module 36
Lab 2: TCP modes 37
Lab 2: TCP Client Mode 38
Lab 2: Auto-Connect 39
Feature 39
Lab 2: Auto Connect 40
Feature (Timers) 40
Lab 2: Alternative GPIO 41
Functions 41
CONFIDENTIAL 43
Lab 2: Forwarding TCP 44
Lab 2: Conclusion 46
Objective 47
Prerequisites 47
Lab 3: Where in the World 48
Wide Web are you? 48
Lab 3: Join Modes 50
Lab 3: FTP Update (REQUIRES 52
Internet Access) 52
Lab 3: Setting Firmware Boot 53
Lab 3: FTP put & get 54
Lab 3: Conclusion 55
Lab 4: HTTP Client 56
Lab 4: Solutions 57
Architecture 57
Lab 4: Enabling HTTP 58
Client Mode 58
Lab 4: Auto-Posting 59
Sensor Data 59
Lab 4: Web Server 60
 Turn Off Auto Connect 61
 Post Data 61
Lab 4: Auto-Posting UART 62
Lab 4: Auto-Posting Serial 63
Lab 4: Conclusion 64
Lab 5: Access Point Mode 65
Lab 5: Creating a Default 66
AP Network 66
Lab 5: Create Custom AP 67
Network in Software 67
Lab 5: Connect to AP Network 68
Created by Module 68
Lab 5: View Associated 69
Devices & Lease Times 69
Wi-Fi Training Session 70

Komentáře k této Příručce

Žádné komentáře

Roving Networks RN-370 Uživatelský manuál Strana 44

Komentáře k této Příručce

Související produkty a manuály pro Sítě Roving Networks RN-370